Capri L4-1597cc 1.6L DOHC (1992)
3. Reverse procedure to assemble. Install stopper plug large end first.
ASSEMBLE
NOTE: Refer to the Exploded Views Of Valve Body images for assembling procedure.
CAUTION: When assembling valve body, do not mix up front and rear gaskets.
Bolt Head Letter Location
CAUTION: Ensure bolt head letter and control valve body letter match.
1. Install orifice check valves and springs in rear control body.
2. Install gaskets on both sides of rear separator, then install onto rear control body.
CAUTION: The rear gasket and main rear gasket are not interchangeable.
3. Install orifice check valves springs and rubber ball in main control body.
4. Install rear control body to main control body.
5. Loosely tighten rear control body bolts.
CAUTION: Ensure bolt head letter matches letter on valve body.
6. Turn assembly over, then install orifice check valves springs, converter relief ball, and spring in main control body.
7. Install orifice check valves, springs, throttle relief ball, and spring in premain control body.
8. Install gaskets on both sides of main separator, then install onto premain control body.
CAUTION: Premain rear gasket and main front gasket are not interchangeable.
9. Set premain control body onto main control body.
10. Loosely tighten premain control body bolts.
CAUTION: Ensure bolt head letter matches letter on valve body.
11. Install orifice check valve and spring in premain control body.
12. Install gaskets on both sides of premain separator, then install on front control body.
CAUTION: Front gasket and premain front gasket are not interchangeable.
13. Install front control body on premain control body.
14. Loosely tighten front control body bolts.
CAUTION: Ensure bolt head letter matches letter on valve body.
15. Install two valve body mounting bolts for alignment.
16. Install front and rear control valve body mounting bolts. Torque bolts to 57-69 in lbs.
17. Install 3-4 solenoid valve and 2-3 solenoid valve with new 0-rings and oil strainer. Torque solenoid valve bolts to 57-69 in lbs.
18. Install brackets and wire harness.
