Capri L4-1597cc 1.6L DOHC (1992)
Clutch Release Bearing: Service and Repair
Clutch Assembly
1.
Disconnect battery ground cable.
2.
Remove transaxle from vehicle.
3.
Install flywheel lock tool T74P-6375-A or equivalent, into transaxle mounting hole on engine, then engage tooth of locking tool into flywheel ring
gear. To avoid dropping clutch disc when bolts are removed, use clutch aligning tool T87C-7137-A or equivalent.
4.
Remove bolts attaching pressure plate to flywheel, then remove pressure plate assembly, Fig. 4.
5.
Remove clutch disc and clutch aligning tool. Use care when removing the last bolt to prevent dropping flywheel.
6.
Reverse procedure to install. Torque pressure plate assembly attaching bolts to 13-20 ft. lbs.
