Capri L4-1597cc 1.6L DOHC Turbo (1991)
7.
Lower and raise the window several times to check the alignment retention.
WINDOW GLASS HEIGHT STOP ADJUSTMENT
1.
Lower the window.
2.
Working through the opening in the lower inner door panel, loosen the stop bracket.
3.
Check the operation of the window.
4.
Adjust the bracket as required.
5.
Tighten the stop bracket nut.
WINDOW GLASS REAR CHANNEL ADJUSTMENT
The rear channel adjustment must be correct to make sure of free movement of the window.
1.
Lower the window.
2.
Loosen the two (2) longitudinal adjustment screws on the adjuster plate at the bottom on the channel, Figure 3.
3.
Raise and lower the window, then tighten the screws.
4.
Loosen the lateral adjuster screw locknut, Figure 3, and turn the adjuster to relieve any strain on the channel.
5.
Tighten the locknut.
6.
Raise and lower the window to be sure that it moves freely.
NOTE: IF THE BATTERY IS NOT IN A FULLY CHARGED CONDITION, IT MAY BE NECESSARY TO START THE ENGINE AND RUN IT
AT FAST IDLE TO PROVIDE SUFFICIENT POWER TO OPERATE THE REGULATOR MOTOR.
SHINGLE WEATHERSTRIP ADJUSTMENT
The shingle weatherstrip is adjustable in the vertical plane. A correctly located shingle weatherstrip has its metal carrier flush with the lower edge of the
convertible top side rail, Figure 2. Adjust the shingle weatherstrip as follows:
1.
Loosen the four (4) retaining screws.
2.
Position the shingle weatherstrip as required.
3.
Tighten the retaining screws.
Completion
After all of the adjustments have been completed, proceed as follows:
1.
Install the door inner panel seals.
2.
Install the door trim and mirror bezel, Figure 2.
PART NUMBER
PART NAME
CLASS
FOJY-7620700-A
Door Inner Panel Seal
(RH)
C
FOJY-7620700-B
Door Inner Panel Seal
(LH)
C
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Eligible Under Basic Warranty Coverage
OPERATION DESCRIPTION
TIME
902507A
One Side
0.6 Hr.
902507AT
Both Sides
1.0 Hr.
DEALER CODING
BASIC PART NO. CONDITION CODE
7020700
07
OASIS CODES:
102000, 110000
