Cougar V6-153 2.5L DOHC VIN L SFI (2001)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Removal
1. Raise and support the vehicle.
2. Remove the Output Shaft Speed (OSS) sensor.
^
Disconnect the OSS sensor electrical connector.
^
Remove the bolt.
^
Inspect the OSS bore.
3. Inspect the O-ring seal for nicks or cuts. Install a new seal as necessary.
Installation
NOTE: Apply a light coat of petroleum jelly to the O-ring before installation.
1. Install the OSS sensor.
^
Connect the OSS sensor electrical connector.
2. Lower vehicle.