Cougar/XR7 L4-140 2.3L SOHC Turbo (1983)
FIGURE 7
T-BIRD/COUGAR
19883 (WITHOUT 2.3L TURBO ENGINE)
1.
Cut the red/yellow hash (640 circuit) wire approximately four inches (4") from the low fluid warning connector and tape back the end coming from
the power source (see Figure 7).
2.
Using a wiring tap (Part No. C7AZ-14487-B), take the remaining red/yellow hash wire and tap into the black/white stripe (941 circuit) wire
leading to the washer pump connector (see Figure 7).
3.
Cover the wiring tap completely with electrical tape.
4.
To check the system, drain reservoir and activate the washer switch. The low fluid warning light should come on only when switch is activated.
