mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Cooling System - Overheating in High Temperatures|Page 2121 > < BMAP Sensor - Loping/Rolling Surge/Stalls
Page 1
background image

Fan Shroud: All Technical Service Bulletins
Cooling System - Overheating in High Temperatures

Article No. 84-6-14

OVERHEATING - DURING HIGH AMBIENT TEMPERATURES (+85~ AND ABOVE) AND PROLONGED IDLE MODE (5.0L)

FORD 1983-84 THUNDERBIRD

LINCOLN-MERCURY 1983-84 COUGAR

A condition of the engine temperature warning light coming on with no loss of coolant during high ambient temperatures and prolonged idle mode may
be serviced using the following procedure:

^

Remove and discard the cooling fan, water pump and pulley.

^

Install a new fan using part number E4SZ-8600-B and the water pump and pulley using part numbers E1AZ-8501-A and E4SZ-8509-A. Torque
attaching bolts to specification.

^

Reinstall the drive belt and set tension to 110-130 lbs.ft.

FIGURE 11

^

On vehicles built prior to January 7, 1984 install right and left radiator air deflectors as shown in Figure 11.

^

Fill the cooling system to correct specification.

^

Verify that the engine hot idle speed is set to specification.

NOTE:

If vehicle usage applies to heavy traffic stop and go driving for long periods of time in hot weather, owner should be advised to occasionally
place the gearshift selector in P (PARK) or N (NEUTRAL) to increase the engine idle speed. This aids in engine cooling and air conditioner

Cooling System - Overheating in High Temperatures|Page 2121 > < BMAP Sensor - Loping/Rolling Surge/Stalls