Cougar/XR7 V8-4.6L VIN W (1997)
9. Remove three screws holding speed control servo to speed control servo bracket.
INSTALLATION
1. Install speed control servo to speed control servo bracket. Tighten screws to 6-7 N.m (53-62 lb-in).
2. Make sure that rubber seal is snug against speed control actuator cable cap.
3. Lock speed control actuator cable ball slug into speed control servo pulley slot.
NOTE: Incorrect wrapping of speed control actuator cable core wire around speed control servo pulley may result in a high idle condition. Make
sure throttle lever is at idle position after speed control cable installation and cable adjustment.
4. Pull on throttle attachment end of speed control actuator cable to draw speed control actuator cable cap on to speed control servo pulley.
5. Insert speed control actuator cable cap locking tabs into speed control servo slots. Rotate cap clockwise until cap locking arm engages cap locking
tab on speed control servo.
6. Position speed control cable and speed control servo in vehicle. Tighten mounting screws to 5.2-7.2 N.m (46-63 lb-in).
7. Attach harness connector to speed control servo.
8. Reinstall front fender splash shield and LH front wheel.
9. Adjust speed control cable.
