Cougar/XR7 V8-4.6L VIN W (1997)
NOTE: Due to the use of a cracked connecting rod joint face surface, the connecting rod cap must be properly aligned to the connecting rod. The
connecting rod and connecting rod cap bearing tangs should be located on the same side of the connecting rod.
5. Install connecting rod caps and alternately tighten new connecting rod cap bolts in several passes to obtain 40-45 Nm (30-33 ft. lbs.) and rotate
connecting rod bolts an additional 90-120 degrees. After installation, rotate crankshaft to ensure smooth operation.
6. Check connecting rod side clearance using Dial Indicator with Bracketry TOOL-4201-C or equivalent. Clearance should be 0.15-0.45 mm
(0.006-0.0177 inch). If side clearance is greater than maximum service limit of 0.50 mm (0.020 inch), replace connecting rods and/or crankshaft.
7. Install oil pump screen cover and tube and oil pan with new oil pan gasket (6710).
