Cougar/XR7 V8-4.6L VIN W (1997)
Harmonic Balancer - Crankshaft Pulley: Service and Repair
REMOVAL
1. Disconnect battery ground cable (14301).
2. Release drive belt tensioner (6B209) and remove accessory drive belt (8620).
3. Raise and support vehicle.
4. Remove crankshaft pulley bolt (6A340) and crankshaft pulley retaining washer (6378) from crankshaft (6303).
5. Install Crankshaft Damper Remover T58P-6316-D on crankshaft pulley (6312) and pull crankshaft pulley from crankshaft.
6. Using front cover seal remover T74P-6700-A, remove the crankshaft front seal.
INSTALLATION
1. Lubricate seal bore in engine front cover (6019) and seal lip with clean engine oil.
2. Using Crankshaft Seal Replacer/Cover Aligner T88T-6701-A, install crankshaft front seal.
3. Using Crankshaft Damper Replacer T74P-6316-B, install crankshaft pulley.
4. Apply Silicone Gasket and Sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6 to end of keyway of crankshaft
pulley as shown.