Cougar/XR7 V8-4.6L VIN W (1997)
2. Position and glue new valve cover gasket onto valve cover. Use Gasket and Trim Adhesive F3AZ-19B508-B meeting Ford specifications
ESR-M11P17-A and ESE-M2G52-A.
NOTE: Install valve cover and retainers no more than four minutes after applying sealer.
3. Apply Silicone Gasket and Sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6 in both places where engine
front cover meets cylinder head.
4. Install valve cover gaskets, valve covers, bolts and studs bolts. Tighten stud bolts and bolts to 8-12 Nm (71-106 inch lbs.) no later than four
minutes after applying sealer.
5. Install ignition wire separators on studs and connect ignition wires to spark plugs.
6. Position and connect fuel charging wiring (9D930) to the electronic variable orifice sensor and oil pressure sensor.
7. Position and connect speed control actuator cable.
8. Connect battery ground cable.
9. Start engine and check for leaks.
