Cougar/XR7 V8-4.6L VIN W (1997)
h. Remove the servo selection tool and dial indicator.
2. Install Servo Piston Remover/Replacer T92P-70023-A to transmission case.
3. Tighten screw on Servo Piston Remover/Replacer T92P-70023-A to allow enough clearance to install retaining ring.
4. Install reverse servo retaining ring and remove tool.
CAUTION: Make sure reverse servo retaining ring is completely seated before removing tool.
5. Install overdrive servo piston return spring and overdrive servo piston assembly. Verify tip of piston assembly engages the pocket of overdrive
band. Using Servo Piston Remover/Replacer T92P-70023-A, install piston assembly into the case and compress overdrive servo piston return
spring.
6. Tighten tool until piston is below retaining ring groove and install retaining ring, remove tool.
7. Install the components for 2-3 accumulator in the following order:
-
upper accumulator seal
-
accumulator piston
