Cougar/XR7 V8-4.6L VIN W (1997)
CAUTION: Failure to mark this position will cause bushing "wind-up" on assembly and incorrect ride height which will cause misalignment and
premature tire wear.
NOTE: When rear suspension arm and bushing bolt is removed from rear wheel knuckle, rear suspension arm and bushing will return to the
relaxed position.
13. Remove RH rear suspension arm and bushing-to-knuckle retaining bolts and nuts.
14. Remove RH halfshaft (inboard CV joint) from rear axle housing using CV Joint Remover T89P-3514-A. Push tool inboard (toward rear axle
housing).
CAUTION: Take extreme care not to damage differential oil seal, case, CV joint boot or axle. Differential oil seals must be replaced when
halfshaft (CV joint) has been removed.
15. Remove halfshaft and rear wheel knuckle assembly from vehicle.
