Cougar/XR7 V8-4.6L VIN W (1997)
6. Take frequent pinion bearing torque preload readings until original preload reading is obtained.
7. If original recorded preload is less than specification tighten used differential pinion bearing to 0.9-1.6 Nm (8-14 in. lbs.) and new differential
pinion bearing to 1.8-3.2 Nm (16-28 in. lbs.). If preload is higher than specification tighten to original reading as recorded.
8. Never back off pinion nut to reduce preload. If reduced preload is required, a new differential drive pinion collapsible spacer and pinion nut must
be installed.
9. Using a jackstand, raise and locate rear axle housing on rear axle differential front lower insulator bolts.
10. Install rear axle differential front lower insulator nuts. Tighten to 92-136 Nm (68-100 ft. lbs.).
