Grand Marquis V8-281 4.6L SOHC (1992)
8.
Use the Spring Selection Chart to select the correct spring three letter code and/or shim combination.
The Front Spring Load Chart provides information about the 410/440/560 lbs/in rate springs which are specifically released for the 1992 Crown
Victoria/Grand Marquis.
CAUTION:
DO NOT USE ANY OTHER SPRINGS THAN THOSE SPECIFIED.
NOTE:
THE 410, 440 AND 560 LBS/IN RATE SPRING ARE SPECIFICALLY RELEASED FOR THE MERCURY GRAND MARQUIS, FORD CROWN
VICTORIA AND FORD/MERCURY HANDLING PACKAGES, RESPECTIVELY. DO NOT USE ANY OTHER SPRINGS THAN THOSE
SPECIFIED ABOVE OR MIX SPRING RATES.
9.
Install the appropriate shim pack (MB-5355-B) and/or spring combination per the Service Manual procedures. Eliminate the potential of
suspension noise by taping the shims and spring insulator to the flat end of the front spring. On reinstallation of the spring(s), ensure that...
a.
There is proper orientation of the spring tail in the lower control arm assembly.
