Grand Marquis V8-302 5.0L VIN F FI (1985)
Fabricated Push Pin Removal Tool
6. With a fabricated push pin removal tool (as shown) or Using the Trim Pad Removing Tool from Rotunda Moulding/Trim Kit 107-00401 or
equivalent, carefully pry the trim panel plastic push pin retainers from the door inner panel.
Note: Do not use trim panel to pry clips from door inner panel. Replace any bent, damaged or missing push pins.
7. Disconnect the radio speaker wiring, if so equipped.
Remove trim panel and watershield.
Installation
1. If trim panel requires replacement, transfer plastic push pins to the new panel.
Ensure that the watershield is positioned correctly to the door sheet metal.
Remove door pull handle from old trim panel and transfer to new trim panel.
2. Position the trim panel loosely to the door belt opening and route the wiring harness through the appropriate access holes in the trim panel.
Connect the radio speaker, if so equipped.
3. Align plastic push pins on trim panel to the holes in the door sheet metal and press pins into place.
4. Install the armrest and route the window regulator, remote mirror cable and power lock harness through the access hole.
5. Install the armrest finish panel.
6. Install the power window regulator switch plate housing to the armrest connecting the power window switch, power door lock switch, and remote
mirror bezel nut, prior to securing the retainer screw.
7. Connect the lock remote rod to the lock knob assembly retainer boss.
Note: Ensure that the remote rod is fully seated into the retainer boss, then function manually or with the power switch to ensure smooth operation
of the lock knob assembly.
8. Install bulb and wiring assembly.
Install lamp lens, if so equipped, and the pull cup assembly.
