Grand Marquis V8-302 5.0L VIN F TBI (1984)
step in the drive coupling.
18.
Check for free movement of the drive coupling on the pin and verify that the pin does not extend beyond the step in the coupling in either
direction.
19.
Remove the distributor from the fixture and check for free rotation.
20.
Install the drive coupling spring in the groove on the drive coupling.
21.
Install the distributor assembly in the engine.
22.
Install the distributor cap and rotor.
23.
Install the TFI module connector.
UNIVERSAL DISTRIBUTOR WITH EEC (OTHER THAN 1.6L)
STATOR ASSEMBLY REPLACEMENT
NOTE:
Do not attempt to replace the stator without an arbor press.
Removal
1.
Using a screwdriver, remove the distributor cap; position the cap and wires aside so as not to interfere with the work area. Remove TFI module
connector.
2.
Remove distributor from block per the distributor removal procedure.
3.
Remove rotor.
4.
Remove the two screws holding the TFI module to the base.
5.
Remove the module, wipe the grease from the base and module, keeping the surfaces free of dirt.
6.
If the distributor uses the push-on rotor, remove the two screws holding the armature and remove the armature.
NOTE:
Hold the gear to loosen the armature screws; do not hold the armature.
7.
To ease reassembly, mark with a felt tip pen, the armature, gear and collar, if present, (refer to the following chart) to note orientation.
8.
Remove and discard pins in gear and collar if present (refer to chart).
GEAR
GEAR
THRUST
ROLL PIN
COLLAR
ENGINE
GEAR PIN
WASHER
EXTRUSION
COLLAR
PIN
2.3L HSC
67555-S
FLUSH
2.3L OHC
67555-S
FLUSH
2.8L
67575-S
FLUSH
3.8L
67555-S
FLUSH
x
67555-S
4 9L
67775-S2
x
EXTRUDE EVENLY,
BOTH SIDES
5.0L
67555-S
FLUSH
x
67555-S
6.1L
67775-S2
EXTRUDE EVENLY,
x
67555-S
BOTH SIDES
7.0L
67775-S2
EXTRUDE EVENLY,
x
67555-S
BOTH SIDES
7.5L
67775-S2
EXTRUDE EVENLY,
x
67555-S
BOTH SIDES
