Grand Marquis V8-302 5.0L VIN F TBI (1984)
REPAIR (Cont'd)
2.
Remove the processor wiring harness connector located in the left (driver side) of the engine compartment up near the brake booster.
3.
Install a harness connector gasket (part number E4AZ-14A297-A) assuring that all of the male pins in connector protrude through the gasket.
4.
Reinstall the processor wiring harness connector. Torque the mounting bolts to 5.4-5.6 N-m (48-50 in.lbs.).
5.
Reinstall the speed control servo to the bracket on the fender apron. Torque the two attaching nuts to 5-7 N-m (45-62 in.lbs.).
6.
Perform a "Key On, Engine Off" Vehicle-In-Process (VIP) self test sequence. Refer to Section 16 of the 1984 Car/Truck Shop Manual - Emission
Diagnosis Engine/Electronics.
PARTS ORDERING INFORMATION
Parts required for this program are available through normal processing channels. Order your parts requirements as needed and assure that parts are
available in your dealership before scheduling the repair.
Service Part Number
Description
Class
Dealer Price
E4AZ-14A297-A
Gasket, Harness Connector
RG
No Charge
Labor Operations, Claim, Program, Notification ( Attachment I) and Owner Letter Information
(Attachment II)
LABOR OPERATIONS
Scheduled Time
Labor Operations
Inspect electronic engine control
0.3 Hr.
SPONPB47A
processor
Inspect electronic engine control
0.6 Hr.
SPONPB47B
processor, install harness connector gasket and perform Vehicle-In-Process (VIP) self test sequence.
Attachment I Page 3 of 3
CLAIM PREPARATION INSTRUCTIONS (A copy of these instructions should be filed in Subject 13.0 of your Warranty and Policy Manual).
Repairs performed under Owner Notification Program B47 may be submitted on warranty claim Form 1863, which is to include the information shown,
below. Enter Program Number B47 in the Program Code box in the upper left of the form. Repair claims should be submitted through the Direct
Warranty Entry (DWE) System.
Causal Basic Part Number - 12A650 Condition Code - 79
Labor Operations - }
-->
See Labor Operations
Scheduled Time - } Program Code - B47
PROGRAM EXPIRATION
This program will remain in effect through November 30, 1984. The electronic engine control processor, however, is eligible for Ford's five-year/50,000
mile Emission Control Defect Warranty coverage.
NOTIFICATION
Vehicles owners are being advised of Owner Notification Program B47 by separate letter (Attachment 11)
IF AN INVOLVED VEHICLE HAS BEEN DELIVERED TO AN OWNER AND THE OWNER'S NAME AND ADDRESS DOES NOT APPEAR ON
YOUR LISTING, PLEASE MAKE ARRANGEMENTS WITH THE OWNER TO RETURN THE VEHICLE FOR THIS SERVICE
PLEASE ASSURE THAT THIS PACKAGE IS PROVIDED TO YOUR APPROPRIATE SERVICE PERSONNEL FOR RETENTION UNTIL
REQUIRED.
ATTACHMENT II
Dear Crown Victoria or Grand Marquis Owner:
The purpose of this letter is to advise you of a service program initiated by Ford Motor Company that involves certain 1984-model Ford Crown Victoria
and Mercury Grand Marquis vehicles. Our records indicate that you own a vehicle eligible for the program which bears the serial number shown on the
envelope that contained this letter. (If you own more than one eligible car, the serial numbers are shown on the listing attached to this letter.)