Grand Marquis V8-302 5.0L VIN F TBI (1984)
Power Window Switch: Service and Repair
Rear Door Window Switch
Removal and Installation
There are 2 styles of Rear Door Window Switches, a door panel mounted and an armrest mounted. The door panel mounted is shown below. For
armrest mounted, please refer to RH Front Door Window Switch procedure. See: RH Front Door Window Switch
1. Remove switch bezel retaining screw from the bottom side of the bezel.
Pivot the lower edge of the bezel out and up to remove the bezel.
2. The switch is held in place by the electrical contact pins.
To remove the switch, carefully pry the switch from the connector with a small screwdriver.
3. To install, position switch to connector and press firmly into place.
4. Install the bezel on the door trim panel and install the bezel retaining screw.
