Grand Marquis V8-4.6L Flex Fuel (2010)
Rear Door Window Motor: Service and Repair
Window Regulator Motor - Rear Door
Window Regulator Motor - Rear Door
Removal and Installation
1. Position the rear door window glass in the full up position and secure with tape.
2. Remove the rear door trim panel.
3. Remove the 2 rivets and the pull handle retainer bracket.
4. Position the water shield aside.
5. Disconnect the rear door window regulator motor electrical connector.
6. NOTE: Use care not to enlarge the sheet metal holes in the door inner panel.
Remove the 2 rear door window regulator rivets.
7. NOTE: Working through the access hole, remove the window regulator motor bracket from the inner panel and slide the motor back to gain
access to the screws.
Remove the 3 rear door window regulator motor bolts.
-
To install, tighten to 6 Nm (53 lb-in).
8. Separate the window regulator motor from the window regulator and remove it from the rear door.
9. To install, reverse the removal procedure.
-
Use the Heavy Duty Riveter to install the new rivets.
