Grand Marquis V8-4.6L Flex Fuel (2010)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in
Vehicle Jacking and Lifting. Failure to follow the instructions may result in serious personal injury.
Remove the rear seat cushion. For additional information, refer to Seats.
2. Disconnect the rear wheel speed sensor electrical connector.
3. Push the wheel speed sensor harness grommet through the passenger compartment floor.
4. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
5. Disconnect the wheel speed sensor harness clips.
6. Remove the rear wheel speed sensor bolt and the sensor.
-
To install, tighten to 7 Nm (62 lb-in).
7. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Vehicle Jacking and Lifting. Failure to follow these instructions may result in serious personal injury.
To install, reverse the removal procedure. If equipped with a fire suppression system, repower the system.