Grand Marquis V8-4.6L Flex Fuel (2010)
Hose/Line HVAC: Service and Repair
Suction Accumulator to Compressor Line
Suction Accumulator to Compressor Line
Removal and Installation
1. Recover the refrigerant.
2. Disconnect the suction accumulator outlet fitting.
-
Discard the O-ring seals.
3. Remove the compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
4. Remove the suction accumulator-to-compressor line.
5. To install, reverse the removal procedure.
-
Install a new gasket seal and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
6. Evacuate, leak test and charge the refrigerant system.
