Grand Marquis V8-4.6L Flex Fuel (2010)
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
All vehicles
1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion.
Police vehicles
2. Remove the zippers from under the material, unzip both the zippers and position the seat backrest cover up to access the seat back trim panel.
3. Remove the seat back trim panel.
1. Remove the 2 screws located at the bottom of the seat back trim panel.
2. Pull out at the bottom and slide the seat back trim panel up to disengage the 2 upper retaining hooks.
Non-police vehicles
4. Release the 3 seat back cover J-clips.
-
Release the lower J-clip.
-
Release the 2 side J-clips.
All vehicles
5. Remove the outboard hog rings that attach the foam pad to the seat backrest frame.
6. NOTE: If installing a new side air bag module, use new retaining nuts. If the same side air bag module is to be reused, reuse the side air bag
