Grand Marquis V8-4.6L Flex Fuel (2010)
14. NOTE: Disengage the steering wheel spring clips from the 2 locking pins on one side of the driver air bag module before proceeding to the other
side.
Repeat the above steps to disengage the 2 remaining driver air bag module locking pins.
15. NOTE: The driver air bag electrical connectors cannot be reversed at installation. Note the electrical connectors position for installation.
Disconnect and remove the driver air bag module.
1. Release the driver air bag module electrical wiring from the driver air bag wiring clip.
2. Squeeze the tabs and disconnect the driver air bag module electrical connector.
3. Squeeze the tabs and disconnect the driver air bag module electrical connector.
4. Disconnect the horn electrical connector.
5. Remove the driver air bag module.
16. Attach a Restraint System Diagnostic Tool to each of the clockspring electrical connectors at the top of the steering column.
17. Separate the RH instrument panel trim panel.
-
Pull out to release the retaining clips.
-
Slide the RH instrument panel trim panel slightly to the right, aligning the keyway.
-
Pull out, separating the RH instrument panel trim panel.
18. Remove the trim panel.
1. Disconnect the rear window defrost switch electrical connector.
