Grand Marquis V8-4.6L Flex Fuel (2010)
2. Inspect the transmission internal harness for damage.
3. Connect the transmission internal harness to the solenoids.
1. Connect the transmission internal harness connector by pressing it in place by hand and fully seating the connector in place.
2. Connect the EPC solenoid by fully seating the connector in place.
3. Connect the TCC solenoid by fully seating the connector in place.
4. Connect the SSA and SSB by fully seating the connector in place.
5. Connect the TFT sensor.
4. NOTICE: The transmission internal wire harness must be properly routed to avoid the potential of damage to the harness. Pinched or
trapped wires may result in a transmission failure.
Make sure the internal wire harness is properly routed.
5. Install the manual control lever. For additional information, refer to Manual Control Lever Shaft and Seal See: Automatic
Transmission/Transaxle/Seals and Gaskets/Service and Repair/Manual Control Lever Shaft and Seal.
6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Vehicle Jacking and Lifting. Failure to follow these instructions may result in serious personal injury.
If equipped with a fire suppression system, repower the system.