Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
Front Door Window Motor: Service and Repair
Front Door Window Regulator Motor
FRONT DOOR WINDOW REGULATOR MOTOR
Removal and Installation
1. Position the front door window glass in the full up position and secure with tape.
2. Remove the front door trim panel.
3. Remove the speaker.
4. Remove the 2 screws and position the driver door module (DDM) aside.
5. Position the upper and lower watershields aside.
6. Disconnect the front door window regulator motor electrical connector.
7. Remove the 3 front door window regulator motor bolts.
-
To install, tighten to 6 Nm (53 lb-in).
8. Partially separate the window motor from the regulator, then press the release tab on the regulator and remove the window regulator motor.
9. To install, reverse the removal procedure.
