mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Caliper Removal and Installation, Front|Page 6002 > < Caliper Removal and Installation, Front|Page 6000
Page 2
background image

5. WARNING:  To avoid injury when using air tools, do not hold flagnuts with fingers. Failure to follow these instructions may result in

personal injury. 

Remove the 4 retainers and the brake caliper anchor plate.
^

To install, tighten to 68 Nm (50 ft. lbs.). 

6. WARNING:  If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire

Suppression System. 

If equipped with fire suppression system, repower the system.

7. To install, reverse the removal procedure.
8. If equipped, turn the air suspension service switch to the ON position.

Caliper Removal and Installation, Front|Page 6002 > < Caliper Removal and Installation, Front|Page 6000