Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Remove the rear brake disc.
4. Remove the adjuster by removing the brake shoe return spring and the adjusting spring.
^
A sharp-pointed tool such as a scratch awl is useful in removing and installing the springs.
5. Remove the parking brake actuator.
^
Push the parking brake shoes toward each other, then pull the parking brake actuator out. Unhook the parking brake cable end.
6. Remove the brake shoe hold-down springs.
7. Remove the parking brake shoe and linings.
8. Inspect the components for excessive wear or damage, and install new components as required.
9. To install, reverse the removal procedure.
^
Using anti-seize lubricant, lubricate the brake shoe contact point before installation of the rear brake shoes.
^
Lubricate the adjusting screw threads with anti-seize lubricant.
^
Using a suitable brake adjusting gauge, set the rear brake shoe and lining diameter to 0.5 mm (0.020 inch) less than the inside diameter of the
drum portion of the brake disc.
^
Adjust the parking brake cable tension.
^
Check the parking brake for normal operation.
10. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire
Suppression System.
If equipped with fire suppression system, repower the system.
