mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Vehicle Lifting|Description and Operation|Page 2413 > < Vehicle Lifting|Description and Operation
Page 2
background image

To lift the rear or either side of the rear end, position the floor jack or the hoist under the rear lift points.

LIFTING

WARNING:  On vehicles equipped with air suspension, the electrical power supply to the air suspension system must be shut off prior to lifting
the vehicle. This can be accomplished by disconnecting the battery or turning off the air suspension service switch located in the luggage
compartment on the LH side. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of
the vehicle during these operations.

CAUTION:

-

Do not allow the hoist adapters to contact the steering linkage, suspension arms, stabilizer bar, rear subframe stabilizer brackets or to
compress the lower suspension arm stabilizer bar insulator. Damage to the suspension, exhaust and steering linkage components may
occur if care is not exercised when positioning the hoist adapters of two-post hoists prior to lifting the vehicle.

-

Never use the differential housing as a lift point. Damage to the differential housing and cover may occur.

Lift the vehicle using the Lifting Points procedure.

Lifting Points - Drive-On Lift

CAUTION:  To prevent possible damage to the underbody, do not drive the vehicle onto the drive-on hoist without first checking for possible
interference.

Check for interference between the upright flanges of the hoist rails and the underbody.

If an interference exists, modify the hoist flanges or build up the approach ramps as necessary to provide clearance.

Lifting Points - Two Post Lift

Vehicle Lifting|Description and Operation|Page 2413 > < Vehicle Lifting|Description and Operation