Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
5. Peel back the rubber splash shield and disconnect the wheel speed sensor electrical connector.
6. Remove the bolts and the wheel bearing and hub assembly.
^
To install, tighten to 100 Nm (74 ft. lbs.).
7. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire
Suppression System.
CAUTION: To avoid sensor or wiring damage, be sure to properly route the wheel speed sensor wiring in front of the stabilizer bar link.
NOTE: During reassembly, verify that the wheel speed sensor electrical connector is fully seated with an audible click, and that the rubber splash
shield is positioned back into place.
To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.