Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
pinion bearings original blend radius has worn to a sharp edge, a new pinion bearing must be installed.
Chuckle
Chuckle that occurs on the coast driving phase is usually caused by excessive clearance between the differential gear hub and the differential case
bore.
Damage to a gear tooth on the coast side can cause a noise identical to a chuckle. A very small tooth nick or ridge on the edge of a tooth can cause the
noise.
Clean the gear tooth nick or ridge with a small grinding wheel. If the damaged area is larger than 3.2 mm (1/8 inch), install a new gearset.
To check the ring gear and pinion, remove as much lubricant as possible from the gears with clean solvent. Wipe the gears dry or blow them dry with
compressed air. Look for scored or damaged teeth. Also look for cracks or other damage.
If either gear is scored or damaged badly, a new ring gear and pinion must be installed.
If metal has broken loose, the axle housing must be cleaned to remove particles that will cause damage. At this time, if any other damaged parts are
found in the axle housing, new parts must also be installed.
Knock
Knock, which can occur on all driving phases, has several causes including damaged teeth or gearset.
In most cases, one of these conditions will occur:
