Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
3. Depower the SRS.
Driver seat only
4. Disconnect the electrical connector.
5. Remove the nut and safety belt buckle.
-
Route the safety belt buckle out from the seat cushion opening.
-
To install, tighten to 40 Nm (30 lb-ft).
Passenger seat only
6. Disconnect the electrical connector
7. Remove the nut and safety belt buckle with belt tension sensor.
-
Route the safety belt buckle out from the seat cushion opening.
-
To install, tighten to 40 Nm (30 lb-ft).
All seats
8. NOTE: Make sure the safety belt buckle is accessible after installation.
To install, reverse the removal procedure.
9. Repower the SRS.
10. Check the active restraints for correct operation.
