Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
2. Remove the ignition switch lock cylinder.
1
Position the ignition switch lock cylinder to the RUN position.
2
Using a suitable tool, push upward on the cylinder release tab while pulling the ignition switch lock cylinder outward.
3. Remove the tilt lever/handle.
4. NOTE: Release the upper steering column shroud by pressing the sides inward.
Remove the 3 screws and the upper and lower steering column shrouds.
^
To install, tighten to 2 Nm (18 inch lbs.).
5. Remove the ignition switch.
1
Disconnect the electrical connector.
2
Remove the ignition switch screw and remove the ignition switch.
^
To install, tighten to 5 Nm (44 inch lbs.).
6. To install, reverse the removal procedure.
^
Repower the SRS. For additional information, refer to Air Bag Systems.
