Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
If equipped with fire suppression system, depower the system.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Remove the clamp plate bolt and disconnect the steering gear lines.
^
Drain the fluid into a suitable container.
^
Discard the O-ring seals.
4. Remove the pressure line-to-engine nut.
^
To install, tighten to 7 Nm (62 inch lbs.).
5. Disconnect the electrical connector from the power steering pressure switch.
6. Disconnect the pressure line-to-pump fitting.
^
Discard the O-ring seal.
-
To install, tighten to 65 Nm (48 ft. lbs.).
7. NOTE: When connecting a fitting with an O-ring seal, a new seal must be installed.
To install, reverse the removal procedure.
^
Using the special tool, install an O-ring seal over a fitting.
^
Fill and leak check the system.
8. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire
Suppression System.
If equipped with fire suppression system, repower the system.
9. If equipped, turn the air suspension service switch to the ON position.