Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
11. Position the steering gear and install the 2 steering gear studs.
-
Tighten to 20 Nm (15 lb-ft).
12. Install the 2 steering gear nuts.
-
Tighten to 103 Nm (76 lb-ft).
13. NOTE: The hex holding feature can be used to prevent turning of the stud while installing the nut.
Position the LH and RH stabilizer bar links and install the 2 nuts.
-
Install new nuts.
-
Tighten to 63 Nm (46 lb-ft).
14. NOTE: The hex holding feature can be used to prevent turning of the stud while installing the nut.
Position the LH and RH tie-rod ends and install the 2 nuts.
-
Install new nuts.
-
Tighten to 80 Nm (59 lb-ft).
15. Lower the vehicle.
16. Connect the intermediate shaft to the steering gear and install the bolt.
-
Tighten to 30 Nm (22 lb-ft).
17. Remove the engine support bar.
18. Install the LH and RH front wheel and tire assemblies.
19. Connect the RH ABS electrical connectors.
