Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
1. If the air spring solenoid valve is functional, use the diagnostic tool to vent the appropriate air spring(s). For additional information, refer to Air
Spring Inflation and Deflation.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Disconnect the electrical connector and the air suspension air line.
1
Disconnect the electrical connector.
2
Compress the quick connect lock ring and pull out on the air line.
4. CAUTION: Remove any dirt or other foreign material from the air spring assembly prior to removing the air spring solenoid valve from the air
spring assembly.
Remove the air spring solenoid retainer.
5. WARNING: The air spring solenoid valve has a 2 stage release. When removing a non functional solenoid and the air spring is inflated,
carefully rotate the solenoid counterclockwise until it reaches the first stage to release the air from the air spring. Turn the solenoid to the
second stage to remove the solenoid. Failure to follow these instructions may result in personal injury.
Rotate the air spring solenoid and remove the solenoid.
6. NOTE: Inspect the O-ring for damage and install a new O-ring as necessary.
Lubricate the solenoid seal area with silicone grease.
NOTE: When installing the air lines, make sure the white air line is fully inserted into the fitting for correct installation.
To install, reverse the removal procedure.
