Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the bolts and position the caliper and anchor plate assembly aside.
^
Support the caliper and anchor plate assembly using mechanic's wire.
4. Remove the brake disc.
5. NOTE: Make sure that the wheel stud being removed is positioned near the access hole on the wheel knuckle prior to installing the special tool.
Using the special tool, press the wheel stud out of the wheel hub flange.
6. Remove the wheel stud.
Installation
1. Install the wheel stud.
1
Install 4 washers onto the wheel stud.
2
Install the wheel nut. Tighten the wheel nut until the wheel stud seats fully onto the wheel hub flange.
2. Remove the wheel nut and washers.
3. Install the brake disc.
4. Position the caliper and anchor plate assembly onto the steering knuckle, and install the bolts.
^
To install, tighten to 160 Nm (118 ft. lbs.).
5. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire
Suppression System.
