Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
Refill
7. Position the magnet into the transmission fluid pan.
8. NOTE: The fluid pan gasket is reusable. Clean and inspect for damage. If not damaged, the gasket should be reused.
Install the fluid pan and gasket.
1
Position the fluid pan with the gasket in place.
2
Install the bolts.
^
Tighten to 14 Nm (10 ft. lbs.).
9. CAUTION: The use of any other transmission fluid can result in the transmission failing to operate in a normal manner or transmission failure.
Fill the transmission.
^
Add 4.7 liters (5 quarts) of clean automatic transmission fluid to the transmission through the fluid filler tube.
10. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
11. With the engine running and the transmission at normal operating temperature 66 - 77°C (150 - 170°F), check and adjust the transmission fluid
level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is achieved (fluid should be
in the cross-hatched area of the fluid level indicator).
12. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire
Suppression System.
If equipped with fire suppression system, repower the system.
Draining
Vehicles without a torque converter drain plug
1. WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to Fire
Suppression System.
With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Maintenance/Service and Repair.
