Grand Marquis V8-4.6L VIN V Flex Fuel (2006)
CAUTION: Remove the rear brake discs to prevent brake drag during drive pinion bearing preload adjustment.
NOTE: When removing the rear brake caliper in this procedure, it is not necessary to disconnect the hydraulic lines.
Remove the rear brake discs and rear brake caliper.
^
Support the rear brake caliper with mechanic's wire.
3. Index-mark the driveshaft flange and pinion flange for correct alignment during installation.
4. Remove the 4 driveshaft bolts.
5. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its
components to disconnect the yoke from the flange. Pry only in the area shown with a suitable tool to disconnect the yoke from the flange.
Using a suitable tool as shown, disconnect the driveshaft centering socket yoke from the rear axle pinion flange.
^
Position the driveshaft aside.
