LN7 L4-098 1.6L VIN 4 2-bbl (1982)
movement is obtained. Usually, 4 moderate blows in each direction on each PGM faceplate will be sufficient. Care should be taken so the hammer
does not glance off and damage body panels.
7.
Add 1/8" thick flat metal washers between the metal collar and the body (2 required each side). This slightly reduces the compression in the rubber
ring and allows greater motion in the bumper
system when it vibrates.
8.
Determine if the faceplates on the PGM units are parallel to each other by scratching the edge of a tape measure across the front face of both
PGM's. If they are more than 1/16" out of line, bend the protruding edge rearward with sharp blows from the large hammer.
9.
Reinstall the bumper and then road test to be certain that no rattles have been created.
Obtain an Authorized Modifications decal and list the date, dealer number and summary of alterations performed. Select a prominent place adjacent to
the Vehicle Emission Control Information decal suitable for installing the Authorized Modifications decal. Clean the area, install the decal and cover it
with a clear plastic decal shield.
OTHER APPLICABLE ARTICLES: 84-6-19
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP17757A84
TIME:
1.9 Hrs. DLR. CODING: Basic Part No. DRIVE Code: H7
