Testing and Inspection: Vacuum Amplifier, EGR Component Information
Vacuum Amplifier: Testing and Inspection
NOTE:
Idle must be set to specifications, engine must be at normal operating temperature and manifold vacuum must be adequate for this test.
Procedure
1. Connect a vacuum gauge hose at EGR valve.
NOTE: The gauge may read as high as 2 inches Hg at idle.
2. Disconnect venturi hose at carburetor and increase engine speed to 2000 rpm on all except 1600 and 2300 cc engines, 4000 rpm on 1600 cc
engines and 3000 on 2300 cc engines.
3. Connect venturi hose. Gauge should read 4 inches Hg.
4. Return engine to idle. Gauge should return to initial reading.
5. If operation is not as described previously, replace VVA.
