LN7 L4-098 1.6L VIN 4 2-bbl (1982)
Altitude Compensator: All Technical Service Bulletins
High Altitude Compensator - New Service Replacement Kit
Article No. 86-21-11
HIGH ALTITUDE COMPENSATOR - NEW SERVICE REPLACEMENT KIT
-
1.6L/2.3L/3.8L
FORD 1981-82 ESCORT, EXP; 1982 MUSTANG, FAIRMONT, GRANADA, THUNDERBIRD
LINCOLN-MERCURY 1981-82 LYNX, LN7; 1982 CAPRI, ZEPHYR, COUGAR, XR7
CALIBRATIONS: 1981 1.6L 1-03W-R0, 1-03W-R10, 1-03X-R10, 1-04W-R10
1982 1.6 L 2-03X-R0, 1-03Y-R10, 2-04X-R0, 2-04Y-R10
1982 2.3L 2-05W-R0, 2-06W-R0 1982 3.8L 2-14W-R0, 2-14X-R0
WARNING:
This modification is authorized only for the listed engines. Performing this modification on other engine calibrations is unauthorized and
could create liability under applicable federal or local laws.
High altitude compensator assemblies (EZ1Z-9A950-A) are no longer available for service. Two new service kits (1.6L: E6PZ-9A950-B, and 2.3L/3.8L:
E6PZ-9A950-A) have replaced the old high altitude compensator assemblies. Based on vehicle application and calibration, use one of the following
procedures for installation.
1981-82 1.6L-2V Installation Procedure:
NOTE:
The procedure is the same as the 1982 1.6L- 2V Escort/Lynx, EXP/LN7 with the exception that there is only one fitting on the carburetor
instead of three. For this application, the remaining two lines should be removed from the harness and the nipples capped.
1.
Remove the old altitude compensator, bracket and hose harness assembly.
2.
Drill a 7 mm hole 65 mm to the left of the existing inboard hole for mounting the new altitude compensator to the bulkhead.
3.
Plug the old outboard hole in the bulkhead.
4.
Install the new altitude compensator.
