LN7 L4-098 1.6L VIN 4 2-bbl (1982)
6.
The high speed air bleeds, main well tubes and main jets are press fit assemblies and can be taken apart by hand (Figure 2).
7.
Replace the primary high speed air bleed, stamped 160, with a 185.
8.
Replace the secondary high speed air bleed, stamped 220, with a 240.
9.
Add one small drop of Loctite 262 or equivalent to the lower threads (Figure 2) and install both primary and secondary assemblies into their
appropriate locations. Torque to 2.0 Newton meters (17 in-lbs).
10.
Install air cleaner bail, stud and retaining pin.
11.
Check and reset, if necessary, all idle speeds.
NOTE:
Whenever it is required to increase Idle speed by more than 100 rpm, or for any decrease in idle speed, the automatic transmission throttle linkage
must be readjusted.
12.
Install the air cleaner assembly.
