LN7 L4-098 1.6L VIN 4 2-bbl (1982)
Choke Plate: Adjustments
1. It is necessary to remove the carburetor to remove the three rivets retaining the choke housing cover. Using a 1/8 inch or No. 30 drill bit, remove
rivet head, then drive rivet out using a 1/8 inch diameter punch.
2. Position fast idle adjusting screw on high step of fast idle cam.
3. Using an external vacuum source, apply 17 inches Hg of vacuum to vacuum channel adjacent to the primary bore on the base of the carburetor.
-
The modulator spring should not be compressed.
4. Using the specified drill, check clearance between choke plate and air horn wall.
-
If clearance is not within limits as listed in Adjustment Specifications, remove choke pulldown motor adjusting screw cover and adjust as
required.
