LN7 L4-098 1.6L VIN 4 2-bbl (1982)
2. Index the insulator on the spring and press insulator DOWNWARD until it snaps into place. Check again to insure insulator is properly indexed
against tip of the spring.
3. Install the spring in control arm and make sure that the spring is properly seated in the spring pocket of the control arm. This must be done prior to
placing spring and insulator into pocket in the body.
4. RAISE control arm and spring with the floor jack. Position the spring in pocket on the underbody.
5. Using a new bolt, nut, and washers, attach control arm to spindle. This bolt is installed with the HEAD to the FRONT of the vehicle. Tighten to
torque of 122-135 N-m (90-100 lb-ft).
6. Install tire and wheel.
7. Remove floor jack and lower vehicle.
