mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Customer Interest for Engine Control Module: > < Muffler - Lack of Power/Stalls/No Start|Page 2272
Page 1
background image

Engine Control Module: All Technical Service Bulletins
Engine - Backfire/Surge/Hesitation

Article No. 85-10-13

HARD START - COLD - ENGINE SURGE/HESITATION AND/OR BACKFIRE ON TIP-IN DURING THE FIRST 2 TO 3 MINUTES OF
OPERATION

FORD 1983 ESCORT, EXP

LINCOLN-MERCURY 1983 LYNX, LN7

CALIBRATIONS: 3-03A-R01-R12-R13

WARNING:

This modification is authorized only for the listed engines. Performing this modification on other engine calibrations is unauthorized and
could create liability under applicable federal or local laws.

Poor cold start, engine surge/hesitation, or backfire on tip-in during the initial 2 to 3 minutes of engine operation after an overnight soak in ambients over
55~F, may be caused by an excessively lean fuel/air ratio. This concern can be serviced by installing a 1984 processor. Since a 1984 processor wiring
connector is different than the 1983 connector, a revised wiring harness (12A581) adaptor is required in addition to other associated EEC system
components.

All parts required for this concern are included in a kit and are priced at $209 net (no stock order discount or PIPP allowance) per kit dealer cost, with a
$100 credit when all substituted parts are returned through the Warranty and Parts Return Center. The pricing is consistent with current processor
pricing. Service kits will be available for a limited time period beginning immediately and ending September 30, 1985.

Authorized Modifications Decal

Obtain an Authorized Modifications decal and list the date, dealer number and summary of alterations performed. Select a prominent place adjacent to
the Vehicle Emission Control Information decal suitable for installing the Authorized Modifications decal. Clean the area, install the decal and cover it
with a clear plastic decal shield.

PART NUMBER

PART NAME

CLASS

E3PZ-12A650-A

1.6L EFI

CG

Cold Drive Kit (Procedure Included in Kit)

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP12650D84
TIME:

1.9 Hrs. DLR. CODING: Basic Part No. DRIVE - Code: F8

Customer Interest for Engine Control Module: > < Muffler - Lack of Power/Stalls/No Start|Page 2272