Lynx L4-98 1.6L SOHC VIN 2 2-bbl (1983)
FIGURE 8
3.
Lift arm rest and base assembly up off of floor support bracket.
4.
Remove the three support bracket to floor retaining screws and remove support bracket.
5.
Drill three new 5/16 diameter mouting holes in support bracket as shown in Figure 8.
6.
Straighten center tab on the front edge of support bracket so that it is parallel with the base of the bracket.
7.
Align the new mouting holes in the support bracket with the existing holes in the floor pan and install the three mounting screws.
NOTE:
When removing the support bracket retaining screws some of the sealer on the screw and washer assembly is removed. Therefore,
when installing the support bracket, body caulk must be applied to the underside of the washer to form a seal between the washer and
support bracket.
