Mariner 2WD L4-2.3L VIN H Hybrid (2006)
Material
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash the
surface with water
Disassembly and Assembly
1. Remove the brake caliper.
2. Secure the brake caliper in a vise.
3. Remove the brake caliper dust boot.
4. Remove the bleeder screw cap.
5. Remove the bleeder screw.
^
To install, tighten to 16 Nm (12 ft. lbs.).
6. CAUTION: Apply moderate air pressure in short bursts to prevent an uncontrolled release of the piston.
NOTE: Inspect the brake caliper piston and bore for excessive wear, corrosion or pitting. If any of these conditions exist, a new caliper must be
installed.
Remove the brake caliper piston.
1. Place a block of wood between the brake caliper piston and the brake caliper housing.
2. Apply compressed air through the brake caliper jounce hose port to remove the piston.
7. Remove the dust boot.
