Mariner 2WD L4-2.3L VIN H Hybrid (2006)
Remove the upper stabilizer bar link nut.
6. Remove the 2 strut-to-knuckle nuts and bolts.
7. NOTE: Reference mark the 4 strut upper bushing plate nuts.
Remove the 4 strut upper bushing nuts.
8. CAUTION: Do not allow the axle shaft to move outboard. Over-extension of the tripod CV joint can result in the separation of internal parts,
causing failure of the axle shaft.
Remove the strut and spring assembly.
9. For additional information on the disassembly and assembly of the strut and spring assembly, refer to Strut and Spring Assembly.
Installation
1. Position the strut and spring assembly upper mounting plate into the inner fender.
2. Align the 4 strut upper bushing nuts to the reference marks.
^
Tighten to 40 Nm (30 ft. lbs.).
3. Install the 2 strut-to-knuckle bolts and nuts.
^
Tighten to 115 Nm (85 ft. lbs.).
4. Install the upper stabilizer bar link nut.
^
Tighten to 63 Nm (46 ft. lbs.).
5. Install the ABS wheel speed sensor harness bolt.
^
Tighten to 23 Nm (17 ft. lbs.).
6. Position the brake jounce hose to the bracket and install the brake jounce hose clip.
7. Check the front end alignment and adjust as necessary.
Disassembly and Assembly
Strut and Spring Assembly
