mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Brakes - Rear Disc Brake Grinding/Rubbing/Thumping|Page 6629 > < Recall - Interior Impact Non-Compliance|Page 6623
Page 1
background image

Headliner: All Technical Service Bulletins
Interior - Headliner Sagging Near Rear Hatch

TSB 05-8-3

05/02/05

HEADLINER SAGGING NEAR REAR HATCH

FORD:
2004-2005 Escape
2005 Escape Hybrid

MERCURY:
2005 Mariner

ISSUE
Some 2004-2005 vehicles may exhibit the headliner sagging around the rear hatch perimeter edge.

ACTION
Adhere the headliner to the underside of the roof panel. Refer to the following Service Procedure.

SERVICE PROCEDURE

1.

Remove the perimeter seal near the sagging edge (Figure 1).

2.

Without removing the headliner push pins, pull the headliner down far enough to scuff/sand the back side of the headliner and the underside of the
roof panel.

3.

Prepare the cartridge of Motorcraft Plastic Bonding Adhesive (TA-9), and apply the adhesive to the back side of the headliner (Figure 2).

Brakes - Rear Disc Brake Grinding/Rubbing/Thumping|Page 6629 > < Recall - Interior Impact Non-Compliance|Page 6623