Mariner 2WD L4-2.3L VIN Z (2005)
Starting on either side of the vehicle, position the supplied drill guide onto the foam block so that the locating pin is set into the indentation on top
of the block and the "wings" are resting on either side of the block, preventing the guide from moving side-to-side. See Figure 4.
4.
WARNING: WEAR SAFETY GLASSES.
CAUTION:
DO NOT USE an air-powered drill for this operation. Oil spray from the tool may damage the foam block or other interior trim.
CAUTION:
Be sure to keep the drill motor at full speed and frequently clear the chips from the bit while drilling each hole. Bore the holes at a slow to
moderate pace using light to moderate pressure on the drill. Attempting to bore the holes at a fast pace using excessive pressure on the drill, or
failing to clear the chips from the bit, may cause the foam blocks to crack.
NOTE:
Be sure to allow the drill motor to achieve full speed before attempting to bore the hole.
Drill the holes as follows:
A.
Holding the drilling guide securely in place, position the drill bit in either of the two (2) guide holes. See Figure 5.
B.
Start the drill motor and allow it to achieve full speed.
